Sierra VISTA, CUSTOM SIZE steel 2 piece set

Sierra VISTA 2 piece steel bushing set.

PLEASE READ: The factory bushings are .522 and .550

I do NOT agree with the .550 and after mic'ing kit fittings at the

 clip end have chosen to go with a .522 for the clip.( and .522 for nib end)

Look closely and you will see that the .550 is the full bead diameter, and the bead ROLLS DOWN to the blank. There is a small flat under the bead where the blank will butt up to it.In my judgement, a .522 will give a nice, pleasing fit.

If turned to.550, your blank would be proud of the hardware where it actually meets, in my opinion!

This is a good example of why I  refer to my bushings as custom.

IF YOU DO NOT AGREE WITH ME, DON"T ORDER THESE!

I can't recommend this set for the computer circuit board kits,the board components are too close

to the surface. You can use these for the computer kits, but be warned!

I would recommend the FACTORY size set for the computer kits.

I now offer "FACTORY SIZE" sets for the Vista, here:http://penturnersproducts.com/index.php?main_page=product_info&cPath=2_3&products_id=100